Start-Up / Operation; Operation; Stopping; Cleaning - Stiga Park series 2WD Instruction Manual

EN
Driver seated.
Parking brake
engaged.
The PTO is
deactivated.
Engine running.
Engine running.
Cutting-means
engaged
Set the cutting-
means assembly
to the maintenan-
ce position.
7 .6

START-UP / OPERATION

When using the machine, the bonnet
must be closed and fastened shut .
Always use full throttle when using the
machine .
1 . Check the PTO is disengaged (9:D).
2 . Do not keep your foot on the service/drive
brake (8:G)
Cold start .
1 . Engage the transmission; push the lever in
(10:A).
2 . Activate the parking brake (8:D)
3 . Put the choke on (8:I).
4 . Turn the key in the ignition (8:L) and start the
engine.
5 . When the engine is running, gradually acce-
lerate (8:I) to maximum operating speed.
Before starting work with the machine,
wait a few minutes for the oil to warm up.
Warm start .
1 . Engage the transmission; push the lever in
(10:A).
2 . Activate the parking brake (8:D)
3 . Turn the control to full throttle (8:I)
4 . Turn the key in the ignition (8:L) and start the
engine.
To proceed see the instructions provi-
ded in heading 7 .6 .1 .
16
Try to start The engine
the engine. turns on
The driver The engine
gets up from is switched
off.
the seat.
The me- Cutting-
chanical means assy
accessory stop.
lift pedal is
taken to the
transport
position.
Try to engage Cutting-me-
the cutting ans assy do
means not engage.
assembly.
ENGLISH

7 .6 .1 Operation

• Press the pedal (8:D) right down then release it.
• Activate the pedal (8:G) to move the machine.
• Go to the work area.
• If front accessories have been installed, acti-
vate the PTO (9:D)
• Commence work.
7 .7

STOPPING

To stop the machine, proceed as follows:
• Disengage the PTO (9:D).
• Engage the parking brake (8:D).
• Turn off the engine by turning the ignition key.
If you have to leave the machine unat-
tended and remove the key from the
ignition .
The engine may be very hot just after it
has been switched off. Do not touch the
silencer .Burns hazard .
7 .8

CLEANING

To reduce the risk of fire, keep the engi-
ne, silencer, battery and fuel tank free
from grass, leaves and oil .
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leaks .
Never use high-pressure water jets.
This can damage axle seals, electrical
components, the hydraulic valves
Always clean the machine after use. To cle-
an the machine adhere to the instructions
provided below:
• Clean the motor (14:A) cooling air intake.
• After cleaning using water, start the machine
and any cutting device assy to remove any wa-
ter which may otherwise end up in the bearings
and cause damage..

8 USING THE ACCESSORY

Make sure the grass to be cut is com-
pletely free of foreign objects such as
stones etc .
8 .1

CUTTING HEIGHT

For best results, cut off the top third of the grass.
(Translation of the Original Instructions)