Pad Volume [Padvol]; Alternate Group [Altgrp] - Yamaha SU10 Owner's Manual

• Trggr (Trigger-driven)
Pressing the pad (or sending a MIDI Note On) causes the sample to play once
through, from Start Point to End Point. The sample does not loop. (But if Loop
Mode is set to RLoop or RShot the sample will play in reverse.) Pressing the
pad again (or sending another MIDI Note On) while play is in progress causes
playback to start over.
PAD VOLUME
Purpose: Sets the sample's relative volume.
Values:
0,...,127
Touch the ribbon; press or hold [–1] or [+1].
To set:
Explanation
Use this setting to adjust the sample volume relative to that of other samples. If
you find that the sample A3 is too loud when played together with sample A4, for
example, you can adjust by lowering the volume for A3 and/or increasing the
volume for A4.
If you play the sample while changing the value, you will be able to hear the level
going up or down.

ALTERNATE GROUP [AltGrp]

Purpose: Selects the sample's alternate group.
Values:
Off, 1, 2, 3
Press [–1], [+1].
To set:
Explanation
You use this feature to identify samples that you do not want to have sounded
together. All samples in the same group become mutually exclusive; playing a
sample from a given group automatically forces off any other sample from that
same group. You can set each sample into any of three groups (1, 2, or 3), or you
can set the value to Off (no group).
44
Editing
Pad Press Pad Release
[PadVol]