Cursor Buttons - Yamaha QY100 Owner's Manual

y [EXIT] Button
the [EXIT] button will take to the next highest level (effectively
"backing up" one step — unless you're already at the top dis-
play).
u Cursor Buttons
screen, highlighting the various parameters that are available for
editing (the QY100 cursor appears as a dark block with inverse
characters).
i [-1/NO] and [+1/YES] Buttons
parameter at which the cursor is currently located. The [-1/NO]
button decrements (decreases stepwise) the value of the
selected parameter, while the [+1/YES] button increments
(increases stepwise) the parameter. Press either button briefly to
decrement or increment the parameter by one, or hold the button
for continous decrementing of incrememnting in the specified
direction.
to "Are you sure?" prompts when they appear. Press [+1/YES] to
go ahead with the operation, or [-1/NO] to cancel.
22
No matter where you are in the QY100 display hierarchy,
These 4 buttons move the "cursor" around the display
TRY THIS:
Select the SONG mode display (use the [SONG] button, as
described above), then try using the cursor buttons to
move the cursor around the screen.
These buttons are used to edit (change the value of) the
The [-1/NO] and [+1/YES] buttons are also used to respond
NOTE
• For even faster decrementing or incrementing, press the opposite incre-
ment/decrement button while holding the button corresponding to the
direction you want to increment/decrement in.
TRY THIS:
Select the SONG mode display (use the [SONG] button, as
described above), use the cursor buttons to select the
transpose parameter ("TRNS" on the display), then try
using the [-1/NO] and [+1/YES] buttons to change its value.
Set it back to "+00" before continuing.
The Controls