Install Hopper - Toro Z-Master Operator's Manual

Installation

Install Hopper

1. Place hopper tilt brackets inside bumper with
tube weld away from the opening. Secure to
bumper with (4) 3/8–16 x 1" (26 mm) bolts and
(4) 3/8–16 flange locknuts (Fig. 12).
4
Figure 12
1. Bumper
2. Tilt bracket weld
3. Bolt 3/8–16 x 1" (26 mm)
2. Position bumper around top rear of frame and
secure in the center with (2) 1/2–13 x 1-1/4"
(32 mm) bolts and 1/2–13 locknuts (Fig. 13).
Secure to outer holes with (2) 1/2–13 x 2-3/4"
(57 mm) bolts and 1/2–13 locknuts.
3. Install ball stud to hopper frame and traction unit
frame tab with 5/16–18 locknut (Fig. 13).
8
6
Figure 13
1. Bumper
2. Bolt 1/2–13 x 1-1/4"
(32 mm)
3. Bolt 1/2–13 x 2-3/4"
(57 mm)
10
1
2
3
m–3803
5
4. Flange locknut 3/8–16
5. Adjustment slot
3
2
5
6
7
4. Locknut 1/2–13
5. Ball stud
6. Locknut 5/16–18
7. Gas spring
8. Safety clip
4. Secure hopper latch to the frame with 1/2"–13 x
1" (25 mm) bolts and 1/2"–13 locknut (Fig. 14).
1
4
1. Hopper latch
2. Bolt 1/2"–13 x 1" (25 MM)
3. Washer 1/2" (13 mm)
5. Place hopper assembly onto frame and align
with holes in bumper mounts. Insert (2) clevis
pins and secure with hairpin cotters (Fig. 15).
6. Adjust tilt brackets in slots (Fig. 12) so chute
opening and hopper opening align at the front.
7. Snap gas spring rod ends over ball stud at frame
and hopper. Secure with safety clips (Fig. 13).
Note: Rod end of gas spring must face the
rear and attach to the traction unit
frame.
2
1
1. Hopper frame assembly
2. Clevis pin 1/2 x 1-1/2"
(38 mm)
2
3
Figure 14
4. Locknut 1/2"–13
5. Front of unit
1
3
Figure 15
3. Hairpin cotter–large
5