Toro Z-Master Operator's Manual page 14

Installation
17. Route hopper full sensor wire harness below
bumper and frame. Connect hopper full sensor
wire harness terminals (3) to round terminal of
main wire harness (Fig. 19).
IMPORTANT: Color codes may not match at
all (3) terminals and must be as follows or
diode will be damaged.
Green – Green or Grey (on some models)
Pink – Pink
Black – Black
18. Push terminals together firmly so latches lock
(Fig. 19).
19. Install wire tie around bumper to hold sensor
wire harness (Fig. 19).
3
1
4
Figure 19
1. Sensor wire harness
2. Round terminals
12
2
3. Latch
4. Wire tie
20. Remove jumper wire from main wire harness
terminal and install interlock switch connector.
Align connector tab and push together firmly so
latch locks (Fig. 20).
Note: After assembly, adjustment of
magnetic switch may be required.
Bend mounting bracket, as required, to
place switch close to magnet on
bottom of hopper.
Figure 20
1. Jumper wire connector
2. Main wire harness
terminal
5
4
3
3. Switch connector
4. Tab and latch
5. Bend bracket
1
2