Troubleshooting - Yamaha MagicStomp Owner's Manual

Troubleshooting

If you encounter problems such as no sound output or abnormal behavior, verify the connections
before checking the following.
<Windows / Macintosh>
The MAGICSTOMP does not receive data from the Sound Editor For MAGICSTOMP.
The sound does not change.
• Is the effect switched "OFF"? Is the MAGICSTOMP in the Tuner Mode, Store Mode, or Name
Edit Mode? Make sure the MAGICSTOMP is in its normal operating mode (select a patch and
switch the effect "ON").
Bulk data is not transmitted.
• Are the MIDI Out port and Device Number set correctly in the Editor Setup?
• Is the editor's dump interval setting too short? Set the dump interval setting to a larger value.
(page 16)
Sound does not change when Monitor button is pressed.
• Are the MIDI Out port and Device Number set correctly in the Editor Setup (OMS Port Setup)?
(page 16)
<Windows>
Bulk data is not received.
• Open the Setup Dialog and check that the Device Number has been properly assigned
MIDI In/Out port is not available in Editor Setup.
• The MIDI In/Out port in Editor Setup is selected from the MIDI In/Out ports in the MIDI Setup.
Check the MIDI In/Out settings in the MAGICSTOMP Setup Toolbar.
<Macintosh>
The USB port is not recognized.
• Check whether the USB driver has been installed to your computer correctly.
No MIDI In/Out data
• Check whether the MIDI IN/OUT setting in the Utility mode corresponds to the actually used
cable (USB or MIDI).
• In the OMS Port Setup, is the MIDI In/Out setting left blank? If you change the OMS ports or
setup, the OMS output ports have to be set accordingly in Sound Editor's OMS Port Setup
window. Choose the appropriate receiving device.
• If the port and setup assignments are frequently altered, OMS may be unable to easily
recognize the port. Reboot the Macintosh, set up OMS correctly, then start up the Sound Editor.
Bulk data is not received.
• Open the OMS Port Setup window and check that the MIDI In has been properly assigned
(page 11).
• Open the Setup Dialog and check that the Device Number has been properly assigned
Sound Editor does not start up when Library File (extension .UB9) is double-clicked.
• Change the Type/Creator settings for Library Files as follows, then try double-clicking the file
again.
Type: UB9_
Creator: UB9E
(page 11)
25
(page 16)
(page 16).
(page 16).