Input/Output Panel - Yamaha EMX5000-12 Owner's Manual

Yamaha powered mixer owner's manual
Hide thumbs Also See for EMX5000-12:
Table of Contents

Advertisement

16
Front and rear panel

Input/output panel

1
Channel input jacks (INPUT A, INPUT B)
EMX5000-20: 1–16, EMX5000-12: 1–8
By using the GAIN control (control panel 2)
you can connect any of the jacks to a wide range
of sources, from mics to line-level devices
(including synthesizers and rhythm machines).
The INPUT A jacks can provide +48V phantom
power, allowing you to use condenser micro-
phones.
The nominal input level is from –16 dB to –60 dB
when the 26 dB pad switch (control panel 1) is
off, or from +10 dB to –34 dB when it is on.
Both INPUT A and B are balanced.
They are compatible with microphones of output
impedance 50–600 or line level devices of
600 .
Pin connections for the jacks are as follows:
INPUT A jacks
(XLR type)
Pin 1: ground
Pin 2: hot (+)
Pin 3: cold (–)
* You can also connect a normal unbalanced phone plug.
2
1
3
+ -
GND
EMX5000-20/EMX5000-12—Owner's Manual
1
3
2
INPUT B jacks
(TRS phone jacks) *
Sleeve: ground
Tip: hot (+)
RIng: cold (–)
S
R
T
-
+
GND
4
5 6
8
7
9
Note: It is not possible to simultaneously use
both the INPUT A and B inputs of a given
channel. For each channel, use only one of the
inputs as appropriate for the input source.
Phantom power is switched on/off simulta-
neously for channels 1–8 and 9–16 (EMX5000-
20), 1–8 (EMX5000-12). For this reason, devic-
es (in particular, unbalanced devices) other
than condenser microphones must be connect-
ed to the INPUT B input jacks of channels or
channel 17/18–19/20 (EMX5000-20), 9/10–11/
12 (EMX5000-12) input jacks if the PHAN-
TOM +48V switch (control panel 3) is on.
2
INSERT I/O (insert) jacks
These are TRS phone jacks that enable you to
insert an external effect processor, such as a com-
pressor/limiter, between the equalizer and fader
of input channels. These connections require a
special "Y" cable, such as shown in the following
diagram. The nominal input/output levels are
0 dB.
to the INSERT I/O jack
Sleeve
Ring
Tip
0
A
E F G
B
D
C
to the input jack of
the external processor
Sleeve
Tip
to the output jack of
the external processor

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emx5000-20Emx5000-20/emx5000-12

Table of Contents