Yamaha EMX5000-12 Owner's Manual page 22

20
Installation/Connections
• Two channel parallel connections
If you connect two speakers in parallel to the SPEAKERS A and SPEAKERS B jacks, use speakers with an
impedance in the range of 8–16 ohms. A maximum output of 500W + 500W will be obtained when 8-ohm
speakers are used.
or
or
When the power amp select switch is set to MONO BRIDGE:
• Bridge connection
Connect only one 8–16 ohm speaker to the A1 jack. The speaker will output the combined monaural signal of
the STEREO bus. A maximum output of 1000 W will be obtained when an 8-ohm speaker is used.
If you are inputting a signal from the P.AMP IN jack, input it to P.AMP IN jack A.
Caution:
When using a bridge connection, do not connect a speaker to the B or A 2 jack.
EMX5000-20/EMX5000-12—Owner's Manual
Two-channel connection
4 –8 4 –8
Main Main/Monitor
Speaker Speaker
* Use either the 1 (Speakon) jacks
or 2 (phone) jacks of and
Bridge connection
No
connection
8 –16
Main Speaker
Two-channel parallel connection
8 –16
Main
Speaker
* Use either the 1 (Speakon) jacks
. or 2 (phone) jacks of
* Use the 1+(+) and 2+(–) pins of the
jack.
No
connection
8 –16 8 –16 8 –16
Main/Monitor
Speaker
and .
1