Using Your Steam Station - Rowenta PERFECT STEAM PRO Instructions For Use Manual

• Unwind the electrical power cord it
completely and remove the steam cord
from its housing-
• Plug your steam station into a 120 volt
fig.7.
electric outlet -
USE
4 • Switching on your steam
station
• Press on the on / off button -
MAX button begins flashing.
• When starting, and regularly while it is
being used, your steam station's electric
pump injects water into the boiler. It makes
a noise but this is quite normal.
• The steam station and the iron are ready for
use when the MAX button light is on and
the iron light goes out.
The first time the appliance is used,
there may be some fumes and a slight
smell this is not harmful and will quickly
disappear.
5 • Using your steam station
• Place the iron's temperature control - fig. 9
to the type of fabric to be ironed (see table
below).
• The iron temperature control light turns
on. Important: whenever you start using
your iron and whenever you reduce the
temperature during use, the iron is ready
for use when its indicator light goes out
and when the green light located on the
control panel comes on and remains on.
• During use, when you increase the
temperature of the iron, you can start
ironing immediately.
T
ype of fabric
S
ynTheTicS
(Polyester, Acetate, Acrylic, Polyamide)
S / W
ilk ool
c / l
oTTon inen
fig.6.
fig. 8, The
S
eTTing
TemperaTure
•
• •
• • •
• ECO Mode: Your steam station
has an ECO mode function which uses less
power whilst still guaranteeing a sufficient
steam output for you to iron your garments
properly.
In order to use this function, once the
thermostat of your iron has been correctly
set (see table above), press on the ECO
button located on the control panel.
The ECO mode can be used on all types
of fabrics, nevertheless for very thick or
very creased fabrics we recommend that
you deactivate ECO mode (by pressing
the MAX button) to guarantee the best
results.
• During ironing the iron indicator light
switches on and off according to heating
requirements but this has no effect on
use.
• To obtain steam, press on the steam
trigger beneath the iron handle and keep
fig.
it pressed -
when you release the trigger.
• Always spray starch on the reverse side of
the fabric to be ironed.
Recommendations: To prime the steam
circuit, either before using the iron for
the first time, or if you have not used
the steam function for a few minutes,
press the steam trigger several times
in a row – fig.11, holding the iron away
from your clothes. This will enable any
cold water to be removed from the
steam circuit.
10
11. The steam will stop