Advertisement
Available languages
Available languages
2. PREPARING YOUR STEAM GENERATOR
1. Place your steam generator on a stable, horizontal heat-resistant work surface.
2. Remove the water tank by pulling the handles upwards (1).
3. Fill the water tank taking care not to exceed the maximum level (2).
4. Replace it fully down in its housing (3).
(1)
The water to use in your steam generator :
Your steam generator has been designed to operate using untreated tap water. However,
if your water is very hard, mix it 50% untreated tap water with 50% distilled water.
Types of water to be avoided :
Do not use water from clothes dryers, scented water, water from refrigerators or air conditio-
ners, rain water.
These contain organic waste or mineral elements that become concentrated when heated and
cause spitting, brown staining or premature wear to the appliance.
3 • USING YOUR STEAM GENERATOR
1. Completely unwind the power cord from its storage space before connecting to an earthed
socket (4).
2. Press on the on / off switch (located on the front of the base unit) (a): the green light (located on
the control panel) flashes and the boiler heats up (b).It will take around 2 minutes for steam to be
produced which is indicated when the green "steam ready" light stops flashing (5).
(4)
• The first time the appliance is used, there may be some fumes and smell but this is not harmful.
They will not affect use and will disappear rapidly.
• When starting, and regularly while it is being used, your steam generator's electric pump injects water into
the boiler. It makes a noise but this is quite normal. You may also hear a clicking noise which is the steam
valve opening. Again this is normal. If you are pressing on the steam control button at this time you may
lose a little steam pressure momentarily.
(2)
(b)
(a)
(5)
(3)
GB
Advertisement
