Connections - Yamaha DIGITAL MIXING STUDIO 01X Owner's Manual

Digital mixing studio
Hide thumbs Also See for DIGITAL MIXING STUDIO 01X:
Table of Contents

Advertisement

• Before connecting the 01X to other electronic components, turn off the power to all the components.
Before turning the power on or off to all components, set all volume levels to minimum (0). Otherwise,
electrical shock or damage to the components may occur.
The following diagram shows a typical example of connections to the 01X. Connect your microphones, instru-
ments, and external devices as shown in this diagram.
Microphone
Synthesizer/Tone generator
Electric guitar/Electric bass
● Wordclock
Digital audio equipment must be synchronized when digital audio signals are transferred from one device to another. Even
if both devices use identical sampling rates, digital signals may not transfer correctly, or audible noise or unwanted clicks
may occur if the digital audio processing circuits inside each digital audio device are not synchronized with each other.
Wordclocks are signals that enable digital audio processing circuits to synchronize with each other. In a typical digital
audio system, one device operates as the wordclock master, transmitting wordclock signals, and the other devices operate
as wordclock slaves, synchronizing to the wordclock master. If you are digitally connecting the 01X to other equipment, you
must decide which device to use as the wordclock master and which devices to use as slaves, then set up all the devices
accordingly. The 01x can be used as the wordclock master running at either 44.1 kHz, 48kHz, 88.2 kHz (Macintosh only),
or 96 kHz, or slaved to an external wordclock source. When mLAN is used, the 01X's mLAN Auto Wordclock must be set to
ENABLE (page 92).
• For information on installing the mLAN driver and connecting the 01X to your computer via mLAN as well as information
on necessary system requirements, refer to the separate Installation Guide.

Connections

MIC/LINE INPUT
1
2
01X
mLAN MUSIC PRODUCTION STUDIO
3 ~ 8
MIDI IN
MIDI OUT
MIC/LINE INPUT
8 (HI-Z)
MONITOR OUT
Monitor system
IEEE 1394-equipped Computer
Copyright(c) Yamaha
PHONES
Headphones
Connections
Foot Switch FC5 or FC4
FOOT
SWITCH
1
2
DIGITAL
STEREO OUT
DIGITAL
STEREO IN
DAT recorder, MD recorder, etc.
23
01X Owner's Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents