Troubleshooting Charger - Stihl HSA 26 Instruction Manual

18 Troubleshooting
Fault LEDs on shrub
shears
The shrub shears cut 3 LEDs emit red
out during operation. light.
The shrub shears
runtime is too short.

18.2 Troubleshooting Charger

Condition LED on Charger
Battery not being One LED glows
charged. red.
LED flashes red.
The charger (3) does The LED (4) glows
not run a self test. green for about
1 second and then
red for about
1 second.
0458-601-9621-A
Cause
Shrub shears are too hot.
There is an electrical fault. ► Remove battery and reinsert it.
The battery is not fully
charged.
The battery service life has
been exceeded.
Cause
Battery too hot or too cold. ► Leave battery in the charger.
No electrical contact
between charger and
battery.
There is a malfunction in
the charger.
There is a malfunction in
the battery.
Electrical contact to
charger was briefly
interrupted.
Remedy
► Remove the battery.
► Allow the shrub shears to cool down.
► Switch on the shrub shears.
► Fully charge the battery.
► Replace battery.
Remedy
Charge process starts automatically as soon as
permissible temperature range is reached.
► Remove the battery.
► Clean contacts on charger.
► Fit the battery.
► Do not use the charger and contact your STIHL
dealer for assistance.
► Do not use the battery and contact your STIHL
dealer for assistance.
► Disconnect the plug from the wall outlet.
► Wait 1 minute.
► Insert the plug in a wall outlet.
English
57