6. M a i nt en a nc e
Cleaning the paper path
Area 2
Areas 1a & 1b
(Optional SFM)
6- 1 6
Use the following procedure to clean excessive paper dust/fibers
from the paper path area.
NOTE: It is recommended that you perform this procedure one
time per day, preferably at the start of the day before the digital
press is switched on and the fuser is hot.
WARNING: If the digital press is switched on and the fuser is hot,
be sure to switch off the digital press power and allow 15 minutes
for the fuser to cool before performing this procedure.
CAUTION: Only clean the recommended areas of the paper path
as described in this procedure.
1. Use a damp, water moistened (not wet), lint-free cloth to clean
the paper path only in the green handle jam clearance areas
as shown below.
Area 3a
Area 7b
Do c u Co l or 8 00 0 /7 00 0 O pe r a to r M a nu a l
Area 3b
Area 7a