Density And Color Balance Adjustment Procedure; Printing A Test Page - Xerox C55/C55mp User Manual

Density and Color Balance Adjustment Procedure

You may notice, over the course of using the printer, that colors may
change. For example, reds may begin to take on a purple cast, or blues
may take on a green cast. This happens during the normal use of a color
printer and can be easily remedied by using the Density/Color Balance
Adjustment procedure described below. This procedure, which should be
done monthly, will help correct any color shifts.
This Control Panel procedure involves printing a test page and adjusting
the densities and colors based on the appearance of the Test Page. You
may need to repeat this procedure and test your adjustments until you
achieve the desired effect.
NOTE:
point; you can do so by pressing the Enter button when <CANCEL
CHANGES> is displayed.

Printing a Test Page

1. Press the On Line button to take the printer off line.
2. Press the Menu button.
3. Press the Next button to scroll through the Top Menu selections.
4. Press Enter when the Top Menu <SETUP MENU> is displayed.
5. Press the Next button to scroll through the sub-menu selections.
6. Press Enter when <COLOR ADJUST> is displayed. The Printer
If, during the adjustment process, you decide to return to your starting
may go through a Print Quality adjustment and the Test Page (See
Figure 7–1) will print.
P R I N T E R M A I N T E N A N C E
7–3