Set Date/Time - Xerox 4635 Operator's Manual

Energy Saver task through

Set date/time

Set Date/Time task through windows
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE
2. If the Enabled button is selected, the Time Out Period
3. Select the appropriate header button:
command line To adjust the time-out period, enter the following command:
ENERGY [timeout]
timeout
Use this task to set the system date and time. The system must
be idle when you perform this task. (Idle means not printing,
offline, and not performing any non-printing tasks.)
Notes:
•
•
1. Select "Set Date/Time" from the System Control menu to
open the Set Date/Time window.
Figure 4-13.
• Select the Disabled button to turn off the energy saver
mode.
• Select the Enabled button to turn on the energy saver
mode.
appears. Enter the number of minutes in the Time Out
Period field. The smallest number that can be entered is 10,
the largest is 65,535.
• Apply/Close. Apply your selection and close the window.
• Apply. Apply your selection.
• Close. Close the window.
The number of minutes after which the energy
saver mode begins. If you do not enter a value,
the current timeout value appears.
You must be at logon level 2 to use this task.
The hours field is specified in military time, that is, 0—23,
with 0 signifying midnight.
Set Date/Time window
Note: When you set the time backwards, the chronological
sequence of records in the console log is no longer valid.
Save and empty the console log. (Refer to the "Console log"
section, which follows.)
SYSTEM CONTROL TASKS
4-13