Suzuki GSF1200SK6 Setup Manual page 7

FORWARD
HANDLEBARS
Loosen the throttle housing retaining screws.
Insert the throttle assembly onto the handlebars.
A: Throttle assembly
B: Handlebars
Install the handlebars assembly using the two clamps,
four Allen bolts and washers.
NOTE:
Install the burring washer in the direction as
shown in the illustration.
The punch mark on the clamps shows front
side.
Align the dot mark on the handlebars with the
mating surface of the front side of left clamp.
A: Clamp
B: 8 × 30 mm Allen bolt
C: Burring washer OD:13.0 mm ID:8.5 mm
D: Punch mark
E: Dot mark
F: Plastic cap OD:11.0 mm
Tighten the handlebar clamp bolts to the specified
torque.
Handlebar clamp bolt: 23 N·m (2.3 kgf-m)
NOTE:
To install the handlebars correctly, first tighten
A of the front side with specified
the bolt
torque and then tighten the bolt
side.
Make sure that the clamp has no clearance at
the front side as shown in the illustration.
After installing the handlebars, fit the plastic cap on the
head of each bolt.
A: 8 × 30 mm Allen bolt
B: 8 × 30 mm Allen bolt
C: Plastic cap OD:11.0 mm
D: Punch mark
6
B of the rear