Suzuki GSF1200SK6 Setup Manual page 11

RIGHT
OUTSIDE
LEFT
A: Bolt
B: Holder
C: Clutch master cylinder
D: Handlebars
Connect the clutch lever position switch lead wires to
the clutch lever position switch.
A: Clutch lever position switch
B: Lead wire
CLAMP
Clamp the handlebar right switch wiring harness and
front brake hose union with strap.
A: Strap L:140.0 mm
B: Front brake hose union
C: Right switch wiring harness
Clamp the handlebar left switch wiring harness and
choke cable with strap.
A: Strap L:140.0 mm
B: Choke cable
C: Left switch wiring harness
OUTSIDE
10
NOTE:
Install the holder in position according to the
mark "UP".
Make sure that the holder has no clearance at
the upper side as shown.
Check for clutch fluid leakage.
NOTE:
Cut the remaining of the strap as shown in the
photograph.
NOTE:
Cut the remaining of the strap as shown in the
photograph.