5. Enrolling
For supervision purposes, the NetworX control panel has the ability to automatically find and store in its
memory the presence of all code pads, zone expanders, wireless receivers, and any other module
connected to the data terminal. This allows these modules to be supervised by the control panel.
Note: All modules should be connected and set to unique addresses prior to enrolling modules. To enroll
the modules, enter the program mode of the NetworX control panel. When the program mode is exited,
the control will enroll the devices. The enrolling process takes about 12 seconds, during which time the
'Service Required' will be displayed. Once a module is enrolled, if it is not detected by the control, the
'Service Required' will be displayed.
6. Programming the Code Pads
This section describes how to program the address and area of each code pad, as well as the available options.
The code pad address allows the control panel to supervise all code pads and report code pad and line failures.
Master Code:
Go To Program code:
6a. Using the Function Menu
Action
Tip: If you know the function numbers
simply press
[ function number].
(
)
example only
#
These are samples of the displays that will scroll automatically
in the function menu.
Table 6-1 provides a list of the function menu items, as well as
page references for further instructions.
NX-148E LCD Code Pad Installation and Setup Manual
Factory Defaults:
when using a 4-digit code, or
when using a 4-digit code, or
Result
Accesses the Function menu.
The display will begin scrolling though available
functions. (See Table 6-1.)
Press the number(s) for the desired function.
Displays the next menu item.
Exits the function menu.
Select an Option
Press
Select an Option
= Zone Review
for a 6-digit code
for a 6-digit code
for help
7