Loading Factory Defaults; Enrolling - GE NX-148E Installation And Setup

Table 3-4 AMERICAN SPANISH LIBRARY
ABAJO CONTACTO
ALARMA CRISTAL
ALMACEN DESPACHO
ARRIBA DETECTOR
AVERIA DISPARO
AZOTEA DOBLE TECHNOLOGIA
BARRERA DORMITORIO
CAJA FUERTE EMERGENCIA
CLARABOYA ENTRADA
COCINA ESTACIONAMIENTO
COMEDOR ESTUDIO

4. LOADING FACTORY DEFAULTS

ACTION
Follow procedures on page 4 (Sections 1 and 2) and enter the Program Mode for the module to default.
The two-line Custom and two-line Shutdown Messages will not be defaulted.

5. ENROLLING

For supervision purposes, the NetworX control panel has the ability to automatically find and store in its
memory the presence of all keypads, zone expanders, wireless receivers, and any other module
connected to the data terminal. This allows these modules to be supervised by the control panel. NOTE:
All modules should be connected and set to unique addresses prior to enrolling modules. To enroll the
modules, enter the Program Mode of the NetworX control panel. When the Program Mode is exited, the
control will enroll the devices. The enrolling process takes about 12 seconds, during which time the
"Service Required" will be displayed. Once a module is enrolled, if it is not detected by the control, the
"Service Required@ will be displayed.
LCD KEYPAD
EXTERIOR
FACHADA
FUEGO
GARAJE
GERENCIA
GOLPE
HABITACION
HUMO
INFORMATICA
INFRARROJO
INTERIOR
#
JARDIN
LABORATORIO
LATERAL
LAVABO
MAGNETICO
OFICINA
PANICO
PARED
PASILLO
PERSIANA
PLANTA
Keypad will beep 3 times (loading is in progress).
The loading takes about 6 seconds.
To load the factory defaults for the LCD keypad,
enter the Program Mode from a different keypad
(does not have to be LCD keypad), and follow the
same procedures.
PRINCIPAL SOTANO
PUERTA TALLER
RECEPCION TECHO
RECIBIDOR TERRAZA
SABOTAJE TIENDA
SALA TRASERO
SALIDA VALLA
SALON VENTANA
SENSOR VESTIBULO
SILENCIOSA ZONA
SIRENA
RESULT
7