6E. Set Code Pad Options - GE NetworX Series Installation And Setup Manual

6e. Set Code Pad Options

Action
[program code]
Code Pad Features
OPT
1 Code Pad Tamper
2 Silent Code Pad?
3 Ding Dong Chime?
4 5 Sec. Silence?
5 Armed Zone Info?
6 Beep On Panics?
7 Disable Service?
8 Master Code Pad?
9 Custom Message?
10 Clock?
11 Custom Msg. Lock?
12 Select an option: Programs special characteristics.
1 = Display 'Press
2 = Disable LED Extinguish on this code pad
3 = On if PIN should be hidden when programming
4 = On suppresses beeps when an RF transmission is lost
5-8 = Reserved (Do not program!)
10
Prompts to 'Please Enter Your Code'.
The LCD will now prompt you through the options
listed on the following chart.
The current state of the option will be shown in
the lower right corner of the display.
Advances to the next option without making
changes.
Otherwise, follow the instructions on the bottom
line of the LCD display to select the desired
option. This will also advance to the next option.
Enable code pad tamper
Enable silent code pad option. If enabled, only the entry/exit and
sounder chime are silenced.
Enable ding dong sound for chime. If off, chime will be a single
tone. (Refer to NX-16 Alarm Panel Installation & Programming
manual, feature 25)
Enable key press silence option. Silences the pulsing code pad
sounder for 5 seconds when a key is pressed.
Enable armed zone information. If on, the LCD code pad will
display faulted or bypassed zone information when the system is
armed.
Enable panic, fire, and medical beep tone. Will sound a short beep
to verify that the key press was accepted.
Suppresses the 'Service' message. This will not allow the 'Service
Required' message to be displayed for any reason. If there is a
system trouble, will still show the 'Service Required' menu.
Enable multi-area mode
Enable custom message display
Enable clock display
Enable custom message lock. Prevents over-writing the custom
message during code pad copy.
For Help'
Result
NX-148E LCD Code Pad Installation and Setup Manual