GE NetworX Series Installation And Setup Manual page 12

Possible Log Messages
Display
Txlobat
ZN Lost
Duress
Man Fire
Aux 2
Panic
KP Tamper
BoxTamp
AC Fail
OverCur
Srn Tamp
Tel Flt
Exp Trb
Log Full
Open
Close
Exit Err
Rec Close
Autotest
Start Prog
End Prog
Start Dnld
End Dnld
Cancel
Gnd Flt
Man Test
Re-exit
Output Trip
Data Lost
Walk-test
End Test
Cross-Trip
Expansion Event
Partial Arm
Listen In
Service Start
Service End
Code Entry
First Open
Last Close
Sprnklr
Clock Set
RF Jammed
CleanMe
12
Description
Transmitter Low Battery - The transmitter has a low battery.
Zone Lost - A wireless or multiplexed zone device is not reporting to the control.
Duress - The control has been armed or disarmed with a duress code.
Manual Fire - Code pad 'Fire' has been activated.
Auxiliary 2 - Code pad 'Medical' has been activated.
Panic - Code pad 'Panic' has been activated.
Code pad Tamper - The code pad tamper has been activated.
Box Tamper - The box tamper circuit has been activated.
AC Fail - AC failure has been detected.
Over Current - A short circuit of a power supply has occurred.
Siren Tamper - A siren or speaker tamper has been detected.
Telephone Fault - A telephone fault or tamper has been detected.
Expansion Trouble - An expansion device or code pad is not reporting to the
control panel.
Log Full - The event log is full.
Open - Reports user number, date, time and area of opening.
Close - Reports user number, date, time and area of closing.
Exit Error - Entry/Exit zone was faulted at the instant the exit delay expired.
Recent Close - An alarm occurred within 5 minutes after the control was armed.
Auto Test - Sending a communicator test at a specified interval.
Start Programming - Local programming is started.
End Programming - Local programming is ended.
Start Download - Download session is started.
End Download - Download session is ended.
Cancel - System is disarmed; Cancel was initiated within 5 minutes of an alarm.
Reserved.
Manual Test - Bell and/or communicator test while system is in disarmed condition.
Re-Exit - The exit delay has been re-started without disarming the system.
Output Trip - A trip has occurred on an expander auxiliary output.
Data Lost - Communication of a signal has failed (log only event).
Walk-Test - A zone 'Walk-Test' mode has been activated.
End Test - Test has been ended.
Cross Trip - The first zone of a cross zone has been tripped (log only event).
Expansion Event - An expansion module has created an undefined event.
Partial Arm - Reports a closing in the stay mode.
Listen In - A listen in function has been activated.
Service Start - Technician is on site.
Service End - Technician is off site.
Code Entry - A code has been entered.
First Open - Reports when the first area is disarmed.
Last Close - Reports when the last area is armed.
Sprinkler - Instant sprinkler supervisory report
Clock Set - Clock has been reset.
RF Jammed - A wireless expansion module is jammed by another RF device
Clean Me - A smoke detector requires cleaning.
NX-148E LCD Code Pad Installation and Setup Manual