Xerox 50 System Administration Manual page 54

2
Enter a new password in the New password box,
Figure 48, by using the numeric keypad. Asterisks
1
display instead of the numbers shown in the
example.
3
Press the Enter button.
4
Enter the same number in the Confirm password
box, Figure 48. Again, asterisks display.
2 2
5
Press the Enter button.
NOTE: If you make a mistake while entering a
value, touch the Reset button, type the number
again, and touch the Enter button.
6
Touch Close to save the new Auditron
Administrator password, Figure 49.
NOTE: Be sure to write down the new Auditron
Administrator password and leave it in a secured
area.
4
KEY POINT: You cannot enter the Auditron
Administration mode without your password. If
you lose or forget your Auditron Administrator
password, contact your Xerox representative.
The Xerox representative will clear the existing
password by returning it to its factory default of
11111.
5
The Auditron Administration screen is displayed,
Figure 50.
7 Touch the Close button to display the Access
screen.
6
8 Touch Close in order to exit and return to the
basic programming screens.
7
METERS, CONSUMABLES, AND AUDITRON
Figure 48: Confirm password window
Figure 50: Auditron Administration screen
2–30 DOCUMENT CENTRE CS 50 SYSTEM ADMINISTRATION GUIDE
Figure 49: Close button