Listening To The Radio - JVC UX-G100 Instructions Manual

Listening to the Radio

To select the band (FM or AM)
FM/AM
FM
To tune in to a station
While FM or AM is selected...
1
sec.
TUNING/GROUP/PTY
Station searching starts and frequency indication starts
changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the searching will stop.
To stop searching manually, press either button.
• When you repeatedly press the button, the frequency
changes step by step.
If the received FM station is hard to listen
FM/AM
FM
Reception will improve though stereo effect is lost. MONO
indicator lights up.
To restore the stereo effect, press FM/AM repeatedly to
select FM.
FM MONO
AM
FM MONO
AM
To preset the stations
You can preset 20 FM and 10 AM stations.
1
Tune in to a station you want to preset.
2
Activate the preset number entry mode.
ISPLAY/
PROGRAM
• Finish the following process while the indication on the
display is flashing.
3
Select a preset number for the station you want to
store.
To select a number, see "How to
!
select numbers" on page 7.
• You can also use the
" # $
% '
&
4
Store the station.
ISPLAY/
PROGRAM
To tune in to a preset station
1
Select a band (FM or AM).
FM/AM
FM
2
Select a number of the preset station you stored.
To select a number, see "How to
!
select numbers" on page 7.
• You can also use the
" # $
% & '
The PROG indicator lights up on the display.
kHz
MHz
PRESET or PRESET
1 y
button.
FM MONO
AM
PRESET or PRESET
1 y
button.
8