Download Print this page

Extron electronics DTP2 R 212 Series Setup Manual page 6

Hide thumbs Also See for DTP2 R 212 Series:

Advertisement

ATTENTION:
Do not connect this device to a computer data or telecommunications network.
Ne connectez pas cet appareil à un réseau de télécommunications ou de données informatiques.
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201 cable to link the matrix switcher to Extron DTP
products, XTP matrix switchers, or HDBaseT-enabled devices.
N'utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF-4 ou le câble STP201 pour relier la grille de commutation à
des produits DTP, à des grilles de commutation XTP ou à des appareils équipés HDBaseT Extron.
To ensure FCC Class A and CE compliance, STP cables and STP connectors are required.
Afin de s'assurer de la compatibilité entre FCC Classe A et CE, les câbles STP et les connecteurs STP sont nécessaires.
Analog audio output connector
Figure 5 shows how to wire the audio output connector. Use the supplied tie-wrap to strap the cable to the extended tail of the connector.
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Do not tin the wires!
Unbalanced Stereo Output
Figure 5.
Audio Output Connector Wiring
ATTENTION:
For unbalanced audio, connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (-) contacts.
Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne PAS connecter les manchons aux contacts négatifs (–).
NOTES:
The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
If the stripped section of wire is longer than 3/16 inch, the exposed wires may touch, causing a short circuit.
If the stripped section of wire is shorter than 3/16 inch, wires can be easily pulled out even if tightly fastened.
Do not tin the leads. Tinned wires are not as secure in the connector and could be pulled out.
RS-232 and IR connectors
Figure 6 shows how to wire the RS-232 and IR connectors.
RS-232 Device
Gnd
Rx Tx
Tx/Rx
Pins
Gnd
Tx Rx
IR Device
Figure 6.
RS-232 and IR Connector Wiring
NOTE:
The length of exposed wires is important (see the audio connectors
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
6
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
RS-232 Device
Gnd
Rx
Tx
on the Extron website.
© 2020 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
RS-232 Device
Gnd
Rx
Tx
NOTES
above for more information).
www.extron.com
68-2986-50 Rev. A
04 20

Advertisement

loading

This manual is also suitable for:

Dtp2 r 212Dtp2 r 212 sa