Rinnai Demand Duo R Series Installation And Operation Manual page 5

This is the safety alert symbol. This
symbol alerts you to potential hazards
that can kill or hurt you and others.
DANGER Indicates an imminently
hazardous situation which,
if not avoided, will result in personal injury or
death.
WARNING
which, if not avoided, could result in personal
injury or death.
CAUTION
which, if not avoided, could result in minor or
moderate injury. It may also be used to alert
against unsafe practices.
WARNING
• Before operating, smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
• Keep the area around the appliance clear and
free from combustible materials, gasoline, and
other flammable vapors and liquids.
• Combustible construction refers to adjacent
walls and ceiling and should not be confused
with combustible or flammable products and
materials. Combustible and/or flammable
products and materials should never be stored
in the vicinity of this or any gas appliance.
• Always check the water temperature before
entering a shower or bath.
• To protect yourself from harm, before
performing maintenance:
− Turn off the electrical power supply by
unplugging the power cord or by turning off
the electricity at the circuit breaker. (The
"On/Off" button on the temperature control-
ler does not control the electrical power.)
Demand Duo™ R-Series Installation and Operation Manual
Indicates a potentially
hazardous situation
Indicates a potentially
hazardous situation
− Turn off the gas at the gas valve, usually
located immediately before the water
heater.
− Turn off the incoming water supply. This
can be done at the isolation valve
immediately before the water heater or by
turning off the water supply to the building.
•
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, do not try to
repair it; call a licensed professional. Force
or attempted repair may result in a fire or
explosion.
•
Do not use this appliance if any part has
been under water. Immediately call a
licensed professional to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
•
Do not use substitute materials. Use only
parts certified for the appliance.
•
Should overheating occur or the gas supply
fail to shut off, turn off the manual gas control
valve to the appliance.
•
Do not adjust the DIP switches unless
specifically directed by this manual or manu-
facturer.
•
Do not use an extension cord or an adapter
plug with this appliance.
•
Any alteration to the appliance or its controls
can be dangerous and will void the warranty.
•
Proper venting is required for the safe
operation of this appliance with 6 in. B-Vent
or greater. Refer to this manual or NFPA 54
for proper venting techniques for fan-assisted
Category 1 appliances.
•
If a water heater is installed in a closed water
supply system, such as one having a
backflow preventer in the cold water supply
line, means shall be provided to control
thermal expansion. Contact the water
supplier or local plumbing inspector on how
to control thermal expansion.
•
Keep the air intake location free of chemicals
such as chlorine or bleach that produce
fumes. These fumes can damage
components and reduce the life of your
appliance.
•
You must follow the installation instructions
and those in "Section 10. Maintenance" for
adequate combustion air intake and exhaust.
•
Make sure the water heater and its water
lines are protected from freezing. Damage
due to freezing is not covered by the
warranty.
5