Rinnai Demand Duo R Series Installation And Operation Manual page 30

1. Locate the electric conduit on the side of
the water heater (Figure 23).
Figure 23
2. Remove the two screws around the outlet
cover. Remove the outlet cover and
prewired outlet (Figure 24).
Figure 24
3. Remove the desired knockout along the
perimeter of the electric box for conduit
installation (Figure 25).
Figure 25
Demand Duo™ R-Series Installation and Operation Manual
4. Install conduit into the knockout opening
and pull the green, white and black wires
into the box.
5. Strip the green, white, and black field sup-
plied wires 1/2 in. Make sure the conductors
are completely bare (Figure 26).
Figure 26
Match the wire colors, then grip the wire
6.
firmly and push the conductor into open
port of the push in connector (Figure 27).
NOTE
Use only one conductor per port. Verify
conductor is fully inserted to the back of
the connector.
Figure 27
30