Measures For Preparation; Unpacking; Transporting; Storage - Samson 3965 Mounting And Operating Instructions

Measures for preparation

4 Measures for preparation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).

4.1 Unpacking

NOTICE
!
Risk of device damage due to foreign parti-
cles entering it.
Do not remove the packaging and protective
film/protective caps until immediately before
mounting and start-up.
Before mounting the solenoid valve island,
proceed as follows:
1. Remove the packaging from the solenoid
valve island.
2. Dispose of the packaging in accordance
with the valid regulations.

4.2 Transporting

− Protect the solenoid valve island against
external influences (e.g. impact).
− Protect the solenoid valve island against
moisture and dirt.
28
− Observe storage temperature depending
on the permissible ambient temperature
(see technical data in section 3.2).

4.3 Storage

NOTICE
!
Risk of valve damage due to improper stor-
age.
− Observe storage instructions.
− Avoid long storage times.
− Contact SAMSON in case of different
storage conditions or long storage periods.
Storage instructions
− Protect the solenoid valve island against
external influences (e.g. impact, shocks,
vibration).
− Do not damage the corrosion protection
(coating).
− Protect the solenoid valve island against
moisture and dirt. In damp spaces, pre-
vent condensation. If necessary, use a
drying agent or heating.
− Observe storage temperature depending
on the permissible ambient temperature
(see technical data in section 3.2).
− Store the solenoid valve island in its
packaging.
EB 3965 EN