Measures For Preparation; Unpacking; Transporting And Lifting; Transporting - Samson 3275 Mounting And Operating Instructions

Measures for preparation

4 Measures for preparation
After receiving the shipment, proceed as
follows:
1. Check the scope of delivery. Compare
the shipment received against the deliv-
ery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).

4.1 Unpacking

Note
Do not remove the packaging until immedi-
ately before mounting.
Proceed as follows to lift and mount the actu-
ator:
1. Remove the packaging from the actuator.
2. Dispose of the packaging in accordance
with the valid regulations.

4.2 Transporting and lifting

DANGER
!
Hazard due to suspended loads falling.
Stay clear of suspended or moving loads.
WARNING
!
Risk of lifting equipment tipping and risk of
damage to lifting accessories due to exceed-
ing the rated lifting capacity.
14
− Only use approved lifting equipment and
accessories whose minimum lifting capaci-
ty is higher than the weight of the actuator.
− Refer to section 3.3 for weights.
NOTICE
!
Risk of actuator damage due to incorrectly
attached slings.
− The lifting eyelets on the cover are intend-
ed for mounting and removing the actuator
as well as lifting the actuator without valve.
Do not lift the entire control valve assembly
using the lifting eyelets.
− Observe lifting instructions (see sec-
tion 4.2.2).
Tip
SAMSON's After-sales Service department
can provide more detailed transport and lift-
ing instructions on request.
4.2.1

Transporting

The actuator can be transported using lifting
equipment (e.g. crane or forklift).
Î Leave the actuator in its transport con-
tainer or on the pallet to transport it.
Î Observe the transport instructions.
Transport instructions
− Protect the actuator against external in-
fluences (e.g. impact).
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
EB 8314 EN