Table of Contents
Advertisement
4 Measures for preparation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received against the deliv-
ery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.1 Unpacking
Note
Do not remove the packaging until immedi-
ately before mounting.
Proceed as follows to lift and mount the actu-
ator:
1. Remove the packaging from the actuator.
2. Dispose of the packaging in accordance
with the valid regulations.
4.2 Transporting and lifting
Tip
SAMSON's After-sales Service department
can provide more detailed transport and lift-
ing instructions on request.
EB 8317 EN
Measures for preparation
4.2.1
Transporting
The actuator can be transported using lifting
equipment (e.g. crane or forklift).
Î Leave the actuator in its transport con-
tainer or on the pallet to transport it.
Î Observe the transport instructions.
Transport instructions
− Protect the actuator against external in-
fluences (e.g. impact).
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
− Protect the actuator against moisture and
dirt.
− The permissible transportation tempera-
ture is between –20 and +65 °C.
4.2.2
Lifting
Due to the low service weight, lifting equip-
ment is not required to lift the actuator (e.g.
to mount it onto a valve).
Note
See valve documentation for more informa-
tion on lifting the entire control valve assem-
bly.
19
Advertisement
Table of Contents
