Adjusting The Set Point; Starting/End Closed-Loop Operation - Samson TROVIS 5724-8 Series Mounting And Operating Instructions

6.1 Adjusting the set point

Necessary configuration (see section 10.2)
− A2.1 = 1 to change the set point at con-
troller [1] C1.SP
− A2.1 = 2 to change the set point at con-
troller [2] C2.SP
Adjusting the set point
Select the set point reading.
Start set point adjustment.
Raise/lower the set point.
After five seconds the reading
changes back to the reading deter-
mined in A3.1. The actuator uses
the newly adjusted set point for
closed-loop control.
If '==' is selected instead of the
value, the set point limit is
reached. In this case, the set point
adjustment is canceled without
changing the set point.
Canceling set point adjustment
or until '==' appears.
After five seconds the reading changes
back to the reading determined in A3.1
without the set point being changed.
EB 5724-8 EN
6.2 Starting/end closed-loop
operation
Necessary configuration (see section 10.2)
− A1.1 = 1
Start closed-loop operation
Start closed-loop operation.
Readings:
'on' during start-up time. Afterwards,
the value resulting from the A3.1 con-
figuration item.
Note
The duration of start-up time is set in the
A1.T.ON parameter in TROVIS-VIEW.
During the start-up time, the actuator stem
moves to the defined positioning value A1.
YP.ON (see section 10.2).
End closed-loop operation
End closed-loop operation.
Readings:
'-' blinks in alternating sequence on
the left and right while the lag time
is running
'--' while closed-loop operation is in-
terrupted
Note
The duration of lag time is set in the
A1.T.OFF parameter in TROVIS-VIEW.
During the lag time, the actuator stem moves
to the defined positioning value A1.YP.OFF
(see section 10.2).
Operation
31