Bowflex MAX TRAINER M6 Owner's/Assembly Manual page 41

Condition/Problem
Console shuts off (enters sleep
mode) while in use
Pedals will not move
Fan will not turn
Unit rocks/does not sit level
to operate
Rubbing sound outside of
Shrouds during operation
Metallic rubbing sound from
within Shrouds during operation
Machine seems to release
Pedals for a moment during
operation
Workout results will not sync
with Bluetooth enabled device
®
Check electrical (wall) outlet
Check connection at front of unit Connection should be secure and undamaged. Replace adapter or connec-
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check magnet position (requires
shroud removal)
Check Speed Sensor (requires
shroud removal)
Pedal locations
Check for blockage of fan
Check leveler adjustment
Check surface under unit
Hardware
Caps
Brake bracket
Belt slip
Current console mode
Total time of workout
Fitness machine
Bluetooth enabled device
®
Fitness App
Assembly / Owner's Manual
Make sure unit is plugged into a functioning wall outlet.
tion at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped, replace
cable.
Be sure cable is connected securely and oriented properly. Small latch on
connector should line up and snap into place.
Unplug unit from electrical outlet for 5 minutes. Reconnect to outlet.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to data cable.
Realign sensor if necessary. Replace if there is any damage to the sensor or
the connecting wire.
Handlebars and apply your weight to the heel of the higher foot. While still
grasping the Static Handlebar, lean back slightly applying more weight onto
the heel. Once the Pedals begin to move, resume your intended workout.
Remove material from fan. Be sure not to move the Handlebars, Legs or
Pedals.
well.
If necessary, detach the Shrouds to help with removal. Do not operate ma-
chine until Shrouds have been replaced.
Adjust levelers until machine is level.
Move machine to level area.
Tightly secure all hardware on the Pedal Arms and Handlebar Arms.
Slightly loosen Caps on Crank Arms
Brake bracket needs to be aligned. Contact Customer Service (if inside US/
Canada) or your local distributor (if outside US/Canada).
Contact Customer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).
Machine must be in Idle Mode to sync. Push the PAUSE/STOP button until
the "GET READY" screen is displayed.
A workout must be longer than 1 minute to be saved and posted by the
Console.
Unplug unit from electrical outlet for 5 minutes. Reconnect to outlet.
Consult your device to be sure that the Bluetooth
enabled on it.
Contact appsupport@nautilus.com (if inside US/Canada) or your local dis-
tributor (if outside US/Canada) for further assistance.
41
Solution
wireless feature has been
®