Jog Buttons - Lincoln Electric APEX 3 Series Operator's Manual

APEX ® 3 SERIES TIG PENDANT MANUAL

Jog Buttons

The following buttons and options are available from
the Jog Menu:
1. GAS PURGE -
• Short Press - Purge welding gas for 3 seconds
• Hold - Continually purges welding gas while held
2. COLD FEED FORWARD -
• Short Press - Feeds wire slightly
• Hold - Feeds wire continuously and accelerates
the WFS
3. COLD FEED REVERSE -
• Short Press - Retracts wire slightly
• Hold - Retracts wire continuously and accelerates
the WFS
Note: Be sure to keep the spool tight as the
wire is retracted
FIGURE 16 - Jog Menu Screen
4. HOME -
• Short Press - Returns the weld head to start-
ing position on the track. The starting position is
determined by previous weld or test start.
5. EXIT -
• Short Press - Returns to Idle Screen
6. LEFT TOGGLE (White Border) -
• Short Press - Travels forward or backward
slightly
• Hold - Ramps travel speed
7. STEERING KNOB -
• Rotate - Moves the oscillation in and out
• Short Press - Centers the oscillation
• Long Press - Starts/stops oscillation test
8. RIGHT TOGGLE (GRAY BORDER) -
• Short Press - Adjusts the torch up and down
• Hold - Ramps adjustment speed
9. WIRE FEED/AMPS -
• No Effect
10. DWELL -
• Short Press - Navigates to Oscillation screen
Dwell option
11. OSCILLATION -
• Short Press - Navigates to Oscillation screen;
width/speed option
12. TRAVEL/VOLTS -
• No Effect
13. START/STOP -
• No Effect
14. SECTOR -
• No Effect
15. RESET –
• Short Press – stops the welding sequence
and all motion
• Twist Release
IMPORTANT! The reset button is not an emergency
stop button. Power is still being applied to the system.
Note: In dual feeder setups, the active wirefeeder is
determined by the direction last traveled.
A-23
OPERATION