RIDGID R4091 Operator's Manual page 31

MAINTENANCE
CLEANING THE SAW
See Figure 45.
 Unplug the saw and water pump.
 Unlock table stop (turning until the slot is horizontal).
 Grasp the table firmly before pulling the table to the front
and off the tool.
 Once the table has been removed, throughly rinse entire
saw using a garden hose. Wipe water tray frame, cut-
ting head arm, rails and bevel feature with a soft cloth.
Lubricate rails, bevel feature and saw arm with light oil
(e.g., WD40).
 Replace the drain plug. Tighten securely.
 Empty dirty water from the water tank and dry off the tool.
CLEANING THE SUBMERSIBLE PUMP
 Unplug pump before handling or cleaning the pump.
 Remove the front cover.
 Using a small brush and/or water, clean any debris or
trash that is trapped on the inside of the pump.
NOTE: To maintain efficiency and extend the life of the
pump, check intake screen before use to make sure it is
clean.
 Rinse filter with clean water
If the pump will not run, try the following solutions:
 Ensure that the intake screen is free of obstructions.
 Make sure that the water hose isn't clogged or knotted.
 Be sure the unit is plugged into a functioning power outlet
and the pump is plugged into the electrical plug.
 Be sure there is adequate water in the water tank and
that the pump switch is turned on.
NOTE: Do not handle the pump while it is connected to a
power source.
31 — English