Operation - RIDGID R4091 Operator's Manual

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Straight line cutting operations such as cross cutting,
mitering, ripping, and beveling
NOTE: This saw is designed to cut man-made tile, pavers,
and stone tile products only.
USING THE PUMP SWITCH
See Figure 23.
The pump switch on the saw arm is used when using the
submersible pump. There are three positions for the pump
switch:
A) With the pump switch in position A (left), the pump will
start when the on/off switch is turned on.
B) With the pump switch in position B (right), the pump
switch is always on and the pump is always running.
C) With the pump switch in position C (middle), the pump
is always off.
ON/OFF SWITCH
See Figure 24.
This saw is equipped with an on/off switch that has a
built-in locking feature. This feature is intended to prevent
unauthorized and possible hazardous use by children and
others.
To turn the saw on:
 Lift the switch to turn ON.
To turn the saw off:
 Press the switch down to turn OFF.
To lock the saw:
 With the saw turned OFF, install a padlock (not included)
through the hole in the switch.
WARNING:
In the event of a power failure or when the tool is
not in use, turn the switch OFF. This action will
prevent the tool from accidentally starting when
power returns.
WARNING:
ALWAYS make sure the workpiece is not in contact
with the cutting wheel before operating the switch
to start the tool. Failure to heed this warning may
cause the workpiece to be kicked back toward
the operator and result in serious personal injury.
WARNING:
To reduce the risk of accidental starting, ALWAYS
make sure the switch is in the OFF position before
plugging tool into the power source.
ON/OFF
SWITCH
20 — English
PUMP SWITCH
ON WITH
ON/OFF SWITCH
(POSITION A)
PUMP SWITCH
ALWAYS ON
(POSITION B)
PUMP SWITCH
ALWAYS OFF
(POSITION C)
PUMP
SWITCH
SWITCH
OFF
PADLOCK
Fig. 23
SWITCH
ON
Fig. 24