Night Closing Procedures - Henny Penny 500 Operator's Manual

3-14. CLEANING THE
DEADWEIGHT
ASSEMBLY (Continued)
3-15. NIGHT CLOSING
PROCEDURES
3-30
4. Clean the deadweight cap and weight in hot detergent water.
Make certain to thoroughly clean the inside of the valve cap and
the deadweight.
5. Clean the deadweight orifice and the inside of the deadweight
assembly body with a clean lint-free cloth.
6. Dry the deadweight and deadweight assembly cap.
7. Replace deadweight and deadweight assembly cap. Finger
tighten the cap.
Step 6
At the end of each day or shift, perform the following procedures:
1. Filter the shortening per Filtering of Shortening Section.
2. Move the main power switch and the thermostat switch to their
OFF positions.
3. Place the fryer basket in a sink for cleaning.
4. Clean the deadweight assembly per Cleaning the Deadweight
Assembly Section.
5. Dump the water from the condensation drain pan.
If disconnection of the cable restraint is necessary, be
sure to reconnect the restraint after the fryer has been
returned to its originally installed position.
Model 500/561/600
703