Morning Start-Up Procedures - Henny Penny LVE-202 Operation Manual

3-4. MORNING START-UP
PROCEDURES
Figure 1
Jan. 2013
1. Place basket support inside of vat. Figure 1.
Failure to place the basket supports in the vats could cause
damage to the burner tubes in gas fryers, or the elements in
electric fryers.
2. Make sure vat is filled with oil to the proper level.
3. Move power switch to the ON position and then press
on heat for the desired vat. If display shows "IS POT FILLED?"
make sure oil is at the proper level (see Section 3-2) and then press
ü
button for "YES".
Unit automatically goes into the Melt Cycle until the oil temperature
reaches 180°F (82°C) and then control automatically exits the Melt
Cycle.
The Melt Cycle may be bypassed, if desired, by pressing
button or X button and holding it for 5 seconds.
The control then shows "EXIT MELT" "YES NO". Press
button for "YES" and vat heats continuously until the set-point
temperature is reached.
Do not bypass the Melt Cycle unless enough oil has melted to
completely cover all of the elements. If the Melt Cycle is bypassed
before all elements are covered, excessive smoking of oil, or a fire
will result.
DO NOT OVERLOAD, OR PLACE PRODUCT WITH
EXTREME MOISTURE CONTENT INTO THE BASKETS. 3
LBS. (1.4 KG.) IS THE MAXIMUM AMOUNT OF PRODUCT
PER FULL VAT AND 1-1/2 LBS. (.68 KG.) FOR THE SPLIT
VATS. FAILURE TO FOLLOW THESE INSTRUCTIONS
CAN RESULT IN OIL OVERFLOWING THE VAT WHICH
COULD CAUSE SERIOUS BURNS, PERSONAL INJURY,
FIRE AND/OR PROPERTY DAMAGE.
3-7
Model LVE-202, 203, 204
to turn
ü
ü