Humminbird PiranhaMAX 165 Installation And Operation Manual page 31

2. Route the power cable from the mount
DOWN through the center hole of the
base. Route the transducer jump cable UP
through the base and mount. (Figure 34)
3. Connect the cables to the control head.
The slots for the plugs are keyed to prevent
reverse installation, and insertion should
be easy. Do not to force the connectors
into the control head. (Figure 35)
4. Pull the power cable through the opening
in the long side of the cable well and
insert it into the battery well (see the
illustration Installing the Cables Onto the
Base).
5. Route the transducer jumper cable (see the
illustration Installing the Cables Onto the
Base) out the long side of the cable well
and follow the arrows on the base.
Installing the Cables Onto the Base
Screws
Figure 36
Transducer
Jumper
Cable
Jumper Cable Well
Power Cable
25
Pulling the Cables Through the Base
Figure 34
Connecting the Cables to the Control Head
Figure 35
PiranhaMAX Portable Case Assembly