Attach The Control Head To The Base And Handle - Humminbird PiranhaMAX 165 Installation And Operation Manual

4. Install the handle onto the base, so that the curved part of the handle
faces towards the back of the base, towards the battery well. Use the
four included #8-32 x 7/16" screws, two on each side, to attach the
handle to the base (see the illustrations Installing the Handle Onto the
Base and Sliding in the Handle). Hand tighten only!
Installing the Handle Onto the Base
Figure 31
NOTE: The handle is keyed so that it only fits onto the base in one direction.

3. Attach the Control Head to the Base and Handle

In this procedure you will install the control head onto the base assembly.
1. Insert the thumbknob bolt through the pivot knuckle on the control
head.
2. Align the pivot knuckle with the mount arms and slide into place,
twisting slightly if necessary, until the unit is firmly seated.
3. Rotate the control head to the desired angle and hand tighten the
thumbknob bolt.
4. Thread the gimbal knob onto the pivot bolt and tighten.
Sliding in the Handle
23
PiranhaMAX Portable Case Assembly