Assemble The Base And Handle - Humminbird PiranhaMAX 165 Installation And Operation Manual

2. Assemble the Base and Handle

In this procedure, you will install the PiranhaMAX mount and handle to the
base of the portable case.
Punching Holes
Figure 29
PiranhaMAX Tilt
and Swivel Mount
PiranhaMAX Portable Case Assembly
Attaching the Mount to the Base
Figure 30
1. Turn the base upside down. Punch
out the mounting holes labeled "C"
with a hammer and a screwdriver (or
an awl) as shown in the illustration
Punching Holes.
2. Turn the base right side up. Line up
the PiranhaMAX mount with the
holes you punched out in step 1.
3. Using a socket wrench and a Phillips
screwdriver, secure the PiranhaMAX
mount to the base with the four
included 3/4" screws, lock washers,
and nuts. Hand tighten only!
22
Base