Wall Mount Packages; Connect Material Hoses - Graco Hydra-clean 24V616 Instructions - Parts Manual

Wall Mount Mount Packages Packages
Wall Wall Mount Packages
1. Ensure the wall is strong enough to support the
weight of the pump assembly and accessories,
fluid, hoses, and stress caused during pump
operation.
2. Ensure that the mounting location has sufficient
clearance for easy operator access.
3. Position the wall bracket at a convenient height
ensuring that there is sufficient clearance for
the fluid suction line and for servicing the
displacement pump.
4. Drill four 7/16 in (11 mm) holes using the
bracket as a template. Use any of the three
mounting hole groupings in the bracket. See
Mounting Hole Layout, page
5. Bolt the bracket securely to the wall using bolts
and washers.
6. Attach the pump assembly to the mounting
bracket.
334187H
32.
Connect Material Material Hoses
Connect Connect Material
1. Connect the suction hose (G) between the pump
fluid inlet and the suction tube (H), using thread
sealant on the male threads.
2. Screw on the suction tube strainer.
3. Place the suction tube in the supply drum, and
adjust it so it is 1 in (25 mm) off the bottom of
the drum. Tighten the thumbscrew of the pipe
hanger onto the drum.
4. Connect the spray hose (J) to the pump outlet
manifold.
NOTE: For two–gun spraying, remove the plug in
NOTE: NOTE:
the manifold and connect another spray hose.
5. Connect the spray gun (K) to the hose.
Installation
Hoses
Hoses
7