Advertisement
Quick Links
Operation
JetRoller
For spray rolled application of architectural paints and coatings.
Not approved for use in explosive atmospheres or hazardous locations.
Model 24U170, 24U172, 24V820, 24V926, 24X605, 24V490,
24V491, 24V492, 24V493, 24W128, 24W129, 25A242
3600 psi (24.8 MPa, 248.2 bar) Maximum Working Pressure
Important Safety Instructions
Read all warnings and instructions in this
manual and in your sprayer, in-line valve, and
™
CleanShot
manuals. Save all instructions.
Related Manuals
™
309642
CleanShot
™
309315
Contractor
180º Spray Nozzle
308244
Roller
Model
Frame
24U170
9"
24U172
9"
24V820
9"
24V926
9.5"
24X605
10.5"
24V490
18 cm
24V491
25 cm
24V492
18 cm
24V493
25 cm
24W128
12" - 18"
24W129
12" - 18"
25A242
18 cm
25A841
9"
All rollers come with a 20" extension. See parts list for details.
* For 18" setting, see page 5 for additional tip options.
™
Shutoff Valve
In-Line Valve
Includes
TIP
In-Line Valve 45° Swivel
LTX721
LTX821
PAA515
PAA721
PAA515
PAA721
WR1223*
PAA515
LTX721
CleanShot
333428H
180° Swivel
EN
ti23593b
Advertisement
Related Manuals for Graco JetRoller 24U170
Summary of Contents for Graco JetRoller 24U170
- Page 1 Operation ™ JetRoller 333428H For spray rolled application of architectural paints and coatings. Not approved for use in explosive atmospheres or hazardous locations. Model 24U170, 24U172, 24V820, 24V926, 24X605, 24V490, 24V491, 24V492, 24V493, 24W128, 24W129, 25A242 3600 psi (24.8 MPa, 248.2 bar) Maximum Working Pressure Important Safety Instructions Read all warnings and instructions in this manual and in your sprayer, in-line valve, and...
-
Page 2: Electrocution Hazard
• Check hoses and parts for signs of damage. Replace any damaged hoses or parts. • This system is capable of producing 3600 psi. Use Graco replacement parts or accessories that are rated a min- imum of 3600 psi. •... -
Page 3: California Proposition
Setup WARNING WARNING WARNING WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals. - Page 4 Setup Read your sprayer, in-line valve, and CleanShot manuals. For best results use sprayer pressure shown below. Al- Assemble JetRoller as shown. Snug extension fittings with wrenches. ways spray at the lowest Then tighten another 1/4 turn [~100 in-lb (11 N m)].
- Page 5 Setup Spray and roll on down stroke, release trigger and roll on upstroke. For best Hand roll sensitive wall areas results near floors and baseboards, release trigger 12-24” (30-60 cm) above (outside corners, adjacent walls, floor and continue to roll to bottom on down stroke. Back roll on upstroke. NOTE: See your in-line valve manual for changing the spray tip and for clearing ti23614a...
-
Page 6: Graco Standard Warranty
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.