Advertisement
P/N 3124450_A
INSTALLING SOLID PARTITIONS
Fasten the cases together through the end frames
with Washers — (5) under the head of Cap Screws —
(6). Thread screws into nut retainers at the locations
(A), (B), (C), (D), (E).
Once all the cap screws and washers are in place,
tighten in the order shown in the illustration.
Do not attempt to draw the cases together with the
cap screws. Push the second case against the partition
and first case, compressing all gaskets. Overtightening
can distort the end frame and cause an incomplete
seal, which will result in poor case performance,
including leakage.
At lower front location, use Hex Head Lock Nut — (7)
and Cap Screw — (6) with Washer — (5) under the
head as shown to fasten the partition between the
cases.
Fasten one 'J' Molding — (8) between the partition
and the door frame on each side as shown in the
illustration using Shoulder Screws — (9).
Note that when fastening through the hinge side of
the door frame, it may be necessary to release the
door retainer so the door opens more than 90°. Refer
to manual that shipped with the door.
Replace rear shelf support, back panels, display racks
and pans, and shelves removed in Step 1.
Once line-up is complete, install bumpers and rails. Be
sure to install the splashguard brackets before wiring
or piping cases.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
9
Freedom Reach-in
Advertisement
