Download Print this page

Hussmann Freedom RFL Quick Installation Manual page 8

Standard & narrow reach-in merchandisers
Hide thumbs Also See for Freedom RFL:

Advertisement

INSTALLATION
8
INSTALLING SOLID PARTITIONS
Apply Donut Gasket — (1)
in end frame recessed locations of both cases as
shown in the illustration.
Apply the wider
Donut Gasket — (2)
Lap gaskets at lower corners.
Check that there are no gaps between gasket
and case.
Do not stretch gasket, especially around corners.
Do not butt gaskets; always overlap joints.
Remove paper backing after gasket is applied to
keep gasket free of debris.
Apply the narrower
Foam Tape Gasket — (3) around the outside of
the donut gasket on both cases.
1. With the left-hand case leveled in its permanent position, move the joining case into alignment approximately
4 in. (102 mm) from left-hand case.
2. Slide the Partition Assembly — (4) between the two cases and raise it to align its joining holes with those in the cases.
3. Insert long narrow rods (or screwdrivers) through three or more joining holes of the cases and the partition to
maintain alignment, then bring the cases firmly together to compress the gaskets against the partition.
P/N 3124450_A
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM

Advertisement

loading

This manual is also suitable for:

Freedom rfmFreedom rflnFreedom rfmn