Advertisement
INSTALLATION
10
INSTALLING ACRYLIC PARTITIONS
Acrylic partitions are most often used in a line-up
to separate cases with different refrigeration
defrost cycles, and are installed as cases are joined.
Joining instructions are provided separately. Be
sure merchandisers have been leveled according
to the installation instructions. Carefully unpack
and inspect the acrylic partition and components to
ensure there is no breakage or damage.
Remove the following from cases:
(A) Bumpers, rails, packing materials, splashguards
from both cases.
(B) Shelves (if installed)
(C) Display racks and pans from ends to be joined.
(D) Remove back panels by lifting up and out near
the bottom. No tools are necessary.
Position the Top Left Retainer — 1 against the edge
of the interior top panel of left case as shown. Fasten
with Screws — 2.
A factory-installed acrylic partition may have a retainer
attached to the back end frame and partition. It is not
used in field installations.
Loosely fasten the Acrylic Partition — 3 and Top
Right Retainer — 4 to the Left Top Retainer using
Screws — 5, Washers — 6, and Locking Nut — 7 as
shown in Figure 3, Detail A.
Fasten the Top Right Retainer — 4 to the interior top
panel of right case using Screws — 2.
P/N 3124450_A
PARTS LIST ACRYLIC
PARTITION
Item # Quantity
Interior Top
Panel of Left
Case
Interior Top
Panel of Left
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Description
1.
1
Retainer, Top Left
2.
6
Screw, #8 x ½"
3.
1
Acrylic Partition
4.
1
Retainer, Top Right
5.
10
Machine Screw, ¼-20 x ½" Flat
6.
20
Washer ¼"
7.
10
Hex Nut, Locking ¼"-20
8.
1
Retainer, Bottom Left
9.
1
Retainer, Bottom Right
10.
1
Retainer, Top Front Left
11.
1
Retainer, Top Front Right
12.
1
Retainer, Closeoff
Interior Top
Panel of Right
Case
Case
DETAIL A
RFL / RFM
RFLN / RFMN
See
Detail A
Advertisement
