Siemens SINUMERIK 840D sl Series Diagnostics Manual page 470

Overview of Alarms
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check display machine data 9803, 9851, 9852, 9853 and 9854 .
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61258
Channel %1 block %2: set parameters for counterspindle chuck in the spindle
image
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameters for the counterspindle chuck have not been set in the spindle view.
Alarm triggered by following cycle: F_SUB_SP.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Specify parameters "ZL1", "ZL2" and "ZL3" in screen form "Tools work offset" > "Spin-
dles".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61259
Channel %1 block %2: program contains new machining steps from ShopMill %4
Parameters: %1 = Channel number
%2 = Block number, label
%4 = ShopMill version
Definitions: The program has been created with a ShopMill version that is higher than the existing
one.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Delete the machining step and reprogram machining if required.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61260
Channel %1 block %2: program contains new machining steps from ShopTurn %4
Parameters: %1 = Channel number
%2 = Block number, label
%4 = ShopTurn version
Definitions: The program has been created with a ShopMill version that is higher than the existing
one.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Delete the machining step and reprogram machining if required.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-470
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005