Siemens SINUMERIK 840D sl Series Diagnostics Manual page 828

Overview of Alarms
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. After exchanging the drive
software, the drives must be installed and started up again. Any MD files that were saved
by the control running under the old version must no longer be used. The old data can be
saved with the installation and start-up tool and this data can also be used again.
Program Con- Clear alarm with the RESET key in all channels. Restart part program.
tinuation:
300404
Axis %1 drive %2 drive MD contains different drive number
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: In the drive MD file loaded in a drive there is a drive number which does not correspond to
this drive.
Reactions: - Mode group not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Files with drive data for a particular drive number must not be copied to another drive.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
300405
Axis %1 drive %2 unknown drive alarm, code %3
Parameters: %1 = NC axis number
%2 = Drive number
%3 = Service number
Definitions: The service number signaled by the drive is not implemented in the NCK. It cannot be
assigned to any alarm number.
Reactions: - Mode group not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Reinitialization of the drive
required.
The search for the precise cause of error can only be performed by the development
team. The displayed error codes are always needed for this. (contact SIEMENS AG, Sys-
tem Support for A&D MC products, Hotline (Tel.: see alarm 1000).
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
300406
Problem in the non-cyclic communication for basic address %1, additional informa-
tion %2, %3, %4
2-828
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005