Siemens SINUMERIK 840D sl Series Diagnostics Manual page 214

Overview of Alarms
• Parameterization via machine data has an error.
• Parameter is faulty (e.g. TRAANG: unfavorable angle value (-> modify machine data,
restart)
Persistent transformation:
• Machine data for persistent transformation are wrong (-> consider dependencies,
change machine data, restart)
Only with active "OEM transformation" compile cycle:
The axes included in the transformation must be referenced!
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify part program or
machine data.
Only with active "OEM transformation" compile cycle:
Reference the axes included in the transformation before selecting transformation.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14410
Channel %1 block %2 spline active at geometry axis changeover
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not allowed to change the assignment of geometry axes to channel axes in a spline
curve definition.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14411
Channel %1 block %2 tool radius compensation active at geometry axis
changeover
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible to change the assignment of geometry axes to channel axes when
tool radius compensation is active.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14412
Channel %1 block %2 transformation active at geometry axis changeover
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible to change the assignment of geometry axes to channel axes when
transformation is active.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
2-214
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005