Removal And Replacement Of Extruding Head; Removal And Replacement Of Auger - Hoshizaki MODULAR CUBELET SERENITY SERIES FS-1022MLH-C Service Manual

8) Plug the unit into the electrical outlet, then move the power switch to the "ON" position
to start the automatic icemaking process.
9) Replace the front panel in its correct position.

3. Removal and Replacement of Extruding Head

1) Remove the front panel, then move the power switch to the "OFF" position.
2) Move the control switch to the "DRAIN" position.
3) Move the power switch to the "ON" position.
4) Allow the water to drain from the evaporator.
5) Move the power switch to the "OFF" position, then unplug the unit from the electrical
outlet.
6) Remove the top and side panels.
7) Remove the strap connecting the spout to the chute assembly, then remove the spout.
8) Remove the cutter bolt and lift off the cutter and washer.
9) Remove the seal bolts and lift off the extruding head.
10) Place the new extruding head in place and tighten down the seal bolts.
11) Replace the washer, cutter, cutter bolt, and spout.
12) Replace the top and side panels in their correct positions.
13) Move the control switch to the "ICE" position.
14) Plug the unit into the electrical outlet, then move the power switch to the "ON" position
to start the automatic icemaking process.
15) Replace the front panel in its correct position.

4. Removal and Replacement of Auger

1) Remove the front panel, then move the power switch to the "OFF" position.
2) Move the control switch to the "DRAIN" position.
3) Move the power switch to the "ON" position.
4) Allow the water to drain from the evaporator.
5) Move the power switch to the "OFF" position, then unplug the unit from the electrical
outlet.
6) Remove the top and side panels.
7) Remove the strap connecting the spout to the chute assembly, then remove the spout.
8) Remove the extruding head seal bolts. Using the cutter, lift out the auger assembly.
9) Remove the cutter bolt, cutter, washer, and dowel pin. Remove the extruding head from
the auger and place on the new auger.
10) Install the new auger.
11) Replace the removed parts in the reverse order of which they were removed.
12) Replace the top and side panels in their correct positions.
46