Mounting Recommendations For Saddle - Hanna Instruments BL120 Instruction Manual

6.3. MOUNTING RECOMMENDATIONS FOR SADDLE

• Select required drill size. See table below for dimension details.
• Place the upper part of the saddle (5) on top of the pipe (3) with the
seal (4) placed over the hole.
• Take the lower part of the saddle (2), together with inserted nuts (1)
and align it under the upper part.
• Insert the screws (7) with washers (6) through the holes and hand
tighten into the mounted nuts.
• With all the screws (7) in place, use a wrench to carefully tighten.
• Place the O-ring (8) provided into the upper saddle.
Probe Saddle (In-line Configuration)
BL120-550
BL120-563
BL120-575
Valve Fittings (Flow Cell Configuration)
BL120-450
BL120-463
BL120-475
Injector Saddle
BL120-250
BL120-263
BL120-275
18
Drill
Pipe
Thread Size
Ø 50 mm pipe 1 ¼"thread
Ø 63 mm pipe 1 ¼"thread
Ø 75 mm pipe 1 ¼"thread
Thread Size
Ø 50 mm pipe ½"thread
Ø 63 mm pipe ½"thread
Ø 75 mm pipe ½"thread
Thread Size
Ø 50 mm pipe ½"thread
Ø 63 mm pipe ½"thread
Ø 75 mm pipe ½"thread
Drill Size
29 mm - 32 mm / 1.14" - 1.26"
29 mm - 32 mm / 1.14" - 1.26"
29 mm - 32 mm / 1.14" - 1.26"
Drill Size
20 mm - 25.4 mm / 0.79" - 1.00"
20 mm - 25.4 mm / 0.79" - 1.00"
20 mm - 25.4 mm / 0.79" - 1.00"
Drill Size
20 mm - 25.4 mm / 0.79" - 1.00"
20 mm - 25.4 mm / 0.79" - 1.00"
20 mm - 25.4 mm / 0.79" - 1.00"
8
7
6
5
4
3
2
1