Connecting The Remote Controller Cable To Indoor Unit - Panasonic CS-RZ25VKRW Service Manual

12.5.5

Connecting the Remote Controller Cable to Indoor Unit

Be sure to turn off the main power before installing and connecting the remote controller.
Otherwise, it will cause the electrical shock.
1 Open front grille complete
(Please refer HOW TO TAKE OUT FRONT
GRILLE).
2 Open the control board cover complete and
terminal board cover complete.
3 Connect remote controller cable 2 to remote
controller 1 and guide the remote controller
cable 2 into the unit through the wire
insertion hole.
4 Guide the remote controller cable 2 into the
remote controller cable holder 5 and tighten
with screws 6. Fasten the remote controller
cable holder to control board with screw 7.
5 Install back terminal board cover complete. Be
careful not to clamp the cable between
terminal board cover and control board.
6 Insert firmly the connector of remote controller cable 2 to indoor PCB connector (CN-RMT) and tighten
green wire from remote controller cable 2 with screw 8 to the grounding location provided.
7 After complete, install back removed parts follow reverse procedure.
Note: Remote controller cable cannot be extended.
Terminal board
cover complete
Screw 6
Remote controller cable 2
CAUTION
Front grille complete
Control board cover
complete
Terminal board
cover complete
Remote controller
cable holder 5
Screw 7
77
Green wire
Screw 8
Remote controller cable 2
Remote controller 1
Connector
(CN-RMT)